Effect of two methods of irrigant agitation on the temperature and cleanliness of sodium hypochlorite associated or not with a chelator: irrigant agitation and influence in temperature

Aim: This study investigated the influence in vitro of different sodium hypochlorite (NaOCl) agitation protocols associated or not with DualRinse (HEDP) on the temperature of the solution. Methods: Forty-eight premolars were instrumented and their apical third sealed to allow a closed irrigation system. The teeth remained immersed in a basin of warm water (37°C). The teeth were divided into the groups: G1 (NaOCl+Passive Ultrasonic Irrigation (PUI)), G2 (NaOCl/HEDP + PUI), G3 (NaOCl + EasyClean (EC)) and G4 (NaOCl/HEDP + EC). The canals were filled with the respective solutions and after 180 seconds the first temperature measurement was taken (T0). Then, the solutions were agitated, following the different protocols, for 60 seconds and a new measurement was performed (T60). The temperature was measured using a digital thermometer for type "K" sensors that was inserted into the middle third of the teeth. At the end of the measurements, the teeth were sectioned and prepared for scanning electron microscopy. The dentinal wall of middle third was graded according to the amount of debris and smear layer remaining on the walls. The results were analyzed using ANOVA test and Tukey's multiple comparisons (p<0.05). Results: G1 and G2 had an average increase in temperature of 1.1°C and 1.65°C, respectively (p>0.05). EasyClean caused a decrease in the temperature of the solutions in both groups, without a significant statistical difference with T0 (p>0.05). Regarding cleaning, it was only possible to observe clean dentinal tubules in the groups with the chelator. PUI discretely increased the temperature of the solution, regardless of the solution. The opposite effect was observed after activation with EasyClean. Conclusion: The association of NaOCl with a chelating agent promoted the cleaning of the dentinal tubules

Consequences of chemical residue formation during potentiation of final irrigation - in vitro study

Seeking to increase the efficiency of endodontic irrigation, the association of different solutions as final irrigant has been investigated, such as sodium hypochlorite with chlorhexidine. The literature shows that the combination of these substances leads to the formation of a brownish precipitate, but does not reveal measurements of the intensity of this precipitate and its consequences. Aim: The present study aimed to evaluate the change in dentin color and the obliteration of the dentinal tubules after the association of sodium hypochlorite (NaOCl) with chlorhexidine (CHX) in the final irrigation. Methods: Fifty sterile human lower premolars were prepared with a ProDesign R 35.05 files and divided into 6 groups. Four different NaOCl concentrations (0.5%; 1%, 2.5% and 5.25%) associated with 2% CHX were tested, in addition to 2 control groups, using only 2.5% NaOCl and 2% CHX, respectively. After the final irrigation protocol, the dentin color change was evaluated by spectrophotometry immediately and after 24 hours, and the dentinal tubule obliteration was assessed by scanning electron microscopy. Results: It was possible to verify that regardless the NaOCl concentration used when associated with CHX, a chemical residue was formed, with consequent dentin pigmentation and tubular obstruction. There was a trend towards increased dentin pigmentation and tubular obstruction due to the deposition of the chemical residue formed by this association. Conclusion: It can be concluded that all concentrations of NaOCl associated with CHX caused color changes and tubular obstruction, being proportional to the concentration of NaOCl used